So You ve Bought Fiat 500 Replacement Key Cost ... Now What

Fiat 500 Replacement Key Fob

If your 500 remote key fob has stopped working, it's time to replace the battery. If you replace the battery and it's still not working the issue could be elsewhere.

At United Locksmith, we specialize in the creation of new keys for old automobiles. We have all the tools and accessories needed to provide this service.

Dead Coin Battery

A dead battery is the most frequent reason for your Fiat 500 keyfob not locking or unlocking the doors. The key fob has an in-built battery that will drain quickly when it isn't frequented enough. If your remote has started to show signs of a loss of range or stopped working in the middle of the night, then your battery may be dead.

Metal clips keep the battery in inside the key fob. If the clips aren't tightly secured, they could result in contact problems that will prevent your remote to receive power. Use a flathead screwdriver break open the retaining clip and remove the battery. Be sure to use an identical replacement battery type of voltage, size and specifications as the original battery.

The key fob might also be damaged or corroded by water exposure. Even a quick bath in soapy, warm water could damage the chip. Keep your key fob dry.

Water Damage

If your key fob isn't working properly, it could be due to water damage. Key fobs are fitted with rubber seals that stop them from being damaged by rain or splashes of water, however it is very important to keep your car keys away from the ocean, pool, and the washing machine!

The key fob is equipped with an electronic chip that sends a message to the immobilizer system of your car. The chip is what allows the 500 to be locked and started. If it gets wet it will cease to function.

If you're looking to determine whether your key fob still functioning You can clean the internal electronics using isopropyl or an electronic cleaner. However, it is probably best to get a replacement from a dealership instead of trying to repair the key fob which is submerged in salt water.

Although a replacement fob may cost you a bit of money, it's far less expensive than having to pay for your fiat 500 key fob not working 500 to be towed to the dealership and repaired! You can also do it yourself by following only a few steps. Make sure you have the correct battery type before you attempt to open your key fob. This task is much simpler than it appears and you can find step-bystep instructions on the internet for nearly any key fob for cars.

Faulty Chip

The chip in the key fob communicates directly with the immobiliser on your car to ensure that your vehicle will start only when the correct keys are inserted. If the chip is damaged, or corrupted in any way your car will not start.

A faulty chip can occur due to a variety of reasons but the most common cause is water damage or the battery being dead. Whatever the reason, it is best to delegate this task to a locksmith since they will be able to repair the chip for you swiftly and at a cost-effective price.

If your key fob will not function after exposure to water that is clean from the tap or rain take it off the battery. Wipe down the electronic component using paper towels. If the key fob still isn't working it's likely to be an issue with the chip and is required to be replaced.

Some people will go to their dealer if they need an entirely new Fiat fob. However, this could be costly. United Locksmith is the best place to go if you are looking to have your Fiat key fob repaired at a reasonable cost. We have the tools and experience needed to fix your Fiat fob quickly and fiat 500 key fob not working professionally. way.

Faulty Receiver Module

Fiat key fobs send an electrical signal to the vehicle, which will unlock and lock doors (and start the car if it has an automatic transmission) up to 50 feet. However, there are some things that can cause the fob to stop functioning. This could be due to a dead coin battery or water damage buttons, worn out buttons and a receiver module issue or signal interference, Click On this website or an electronic chip that is malfunctioning.

If the fob has been in a pocket which has been subject to extreme trauma, such as falling on hard floor or being washed in a washer, it may not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is secured and will only accept a signal from a genuine key and not any other.

You will need to replace the fob in case this happens. A professional locksmith will handle the entire replacement process including programming a new key to your 500. In fact, they can provide you with a replica key that functions the same as your original fob (and costs only a fraction of the price).